.
- Thread starter TrailCy
- Start date
I bought a set of metal hangers with hooks on them to hang shovels, weed eater, rakes, bikes etc. They are rubber coated and if you have a drill you can set it up however you want. Check on amazon. https://www.amazon.com/Smartology-H...jbGlja1JlZGlyZWN0JmRvTm90TG9nQ2xpY2s9dHJ1ZQ==
These are what I have.
These are what I have.
Shelving just buy some right angle metal braces, then cut some 3/8 or 1/2 inch plywood to fit, screw the bracing to the garage studs, screw the plywood onto the bracing and your good to go. All you would need for tools are a drill, level, and a saw to cut the plywood.
Ignore the mess but these are ply, some 2x4s, chain and some eye bolts. They’re strong enough that I’ve stored the push mower up there during the winter.
I don’t think I’ve ever seen anything overhead like this pre made. You can buy the plywood in 2x4 or 2x8 sheets so at that point it would be cutting a 2x4, finding the studs and setting some screws.
I don’t think I’ve ever seen anything overhead like this pre made. You can buy the plywood in 2x4 or 2x8 sheets so at that point it would be cutting a 2x4, finding the studs and setting some screws.
Last edited:
Normally, I'd suggest 2x's to make shelves out of. But the prices right now all wood is stupid expensive. Wire shelving may end up cheaper these days. Either way, I like to use wall standards with brackets to allow for adjustability in shelf height.